The correct installation of planetary gear box is an important link to ensure the normal operation of mechanical equipment. Therefore, when you install the planetary reducer, please be sure to strictly follow the following installation and use related matters, carefully assembled and used.
Before installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of the parts connected with the motor and the reducer match. Here are the dimensions and tolerances of the positioning boss of the motor, the input shaft and the reducer groove.
Unscrew the screws on the dust hole outside the reducer flange, adjust the pcs system clamping ring to align its side hole with the dust hole, insert the hex and tighten. After that, remove the motor shaft key.
Connect the motor to the reducer naturally. When connecting, it must be ensured that the output shaft of the reducer is consistent with the input shaft of the motor, and the outer flanges of the two are parallel. If the degree is inconsistent, it will cause the motor shaft to break or the gear of the reducer to wear.
This information is taken from experience without authorization
Before installation, the motor input shaft, positioning boss and reducer connection parts of the anti-rust oil with gasoline or zinc sodium water wipe. Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.
Before connecting the motor to the reducer, make the motor shaft keyway perpendicular to the tightening bolt. To ensure even force, screw the mounting bolts in any diagonal position first, but do not screw them tight. Then screw the other two diagonal mounting bolts and screw the four mounting bolts one by one.
Tighten the force bolt. All tightening bolts need to be fixed and checked with a torque wrench according to the fixed torsional torque data indicated.