Precision electroplating filter is used in electroplating, surface treatment, metal finishing, PCB etching equipment, pharmaceutical environmental protection, etc. Its main role is to filter chemical solutions, which can remove insoluble particle impurities in these solutions. The filter material of the precision electroplating filter also needs to be exchanged frequently, and the filter material is exchanged as follows
This content has been taken from experience without authorization
2. Open the exhaust valve so that the air enters the main barrel, and the liquid in the barrel flows into the plating tank through the filter material. Close the filter outlet ball valve after about 3 minutes. At this time, there is residual liquid at the bottom of the filter bucket of the filter, open the drain valve and drain the liquid to the external bucket, and the liquid can be recycled and used.
3. Turn the red handle counterclockwise to loosen and open the cover.
4. After opening the upper cover of the nut type electroplating filter, the lock cap of the filter element can be loosened to remove the filter material. The filter element can be removed by opening the tie of the filter bag seal.
5. After opening the upper cover of the platen type electroplating filter, turn the column fixing screw counterclockwise and remove it. Lift up the pressure plate, and the filter material can be removed smoothly. The filter material is composed of a filter element, a spring and an upper pad, which can be decomposed when taken out.
6. Clean or replace the filter element and filter bag, and reinstall it into the filter according to the above disassembly method
The electroplating filter is not clean or does not produce water, etc., and there is a case that the filter material is too dirty and needs to be cleaned, so it must be skilled to exchange the filter material quickly.