In the decoration process, the general mason master will use two kinds of processes in the tiling stage. The most common is the floor tile pressure wall tile, and there is a higher requirement for workers, it is the process of wall tile pressure tile, requiring workers to paste the floor tile first when pasting the tile, and then paste the tile after the end. Why do bathroom tiles use wall tiles and floor tiles, which also starts from the advantages of wall tiles and floor tiles.
First, why is it difficult to say that the process of wall tiles is difficult, that is, after the tile is laid, the bottom piece of wall tiles is pressed on the floor tiles. Lay the wall tiles first, but the bottom row is empty, then lay the floor tiles, and finally fill in the last row of wall tiles to hold the floor tiles down. If it is a floor tile pressure wall tile, the general construction order is the bricklayer from the bottom of the wall tile, all the way up the wall tile covered, and then lay the floor tile; And to achieve the wall brick pressure tile, it can not be pasted from the bottom wall brick, but from the penultimate wall brick to stick upward, so that the floor tile is paved, and then the bottom wall brick is embedded in, just pressed on the floor tile. Hanging wall tiles are much more difficult than sticking from the ground, there is no support underneath, it is difficult to ensure that the cement is completely stuck before drying, so falling bricks are always inevitable. Another difficulty of hanging tiles is the need to level the hanging string so that the bricks on each wall remain flat.
1, in the process of wall tiles, there is a joint between wall tiles and floor tiles, that is to say, if there is water on the wall, it will eventually flow down the seam to your waterproof layer, and it will not penetrate and accumulate there, long term, it will certainly not be a good thing? 2. What about wall tiles and floor tiles? The water flowing down the wall flows directly into the glaze of the floor tile, and because the paving tile will not be flat, it must form a slope to the drain, so the water will not accumulate, and finally flow into the drain. 3. In the process of floor tile pressing wall tile, the floor tile is on the top of the wall tile, and the brick also has the expansion coefficient of thermal expansion and cold contraction, which will cause the ground temperature to change greatly due to geothermal. If the thermal expansion for a long time, there is no room for expansion, the wall brick will be squeezed for a long time, and finally affect the service life of the wall brick and floor tile; 4. In the process of wall tile pressing, the floor tile does not directly top the wall tile, but has a certain room for expansion and contraction with the cement wall behind the wall tile, so as to ensure that the ceramic tile will not be squeezed during the process of thermal expansion and cold contraction. On the whole, the advantages of wall tiles are still many, wall tiles, if there is water on the wall, you can directly fall to the ground and flow down the floor into the drain. Moreover, if it is a family laying floor heating, the wall tile can better protect the wall tile and make the service life of the wall tile.